223 / 235
< 8 >
12.
Trouble-Shooting
13.
Storage Instruction
1.
Unscrew the die fixing bolt and remove the jig and die with wrench.
2.
Clean all components and swaging unit body.
3.
Wind the power cord around the red holder on the back.
4.
Keep all of components and accessories in the supplied sturdy plastic case.
No.
Problems
Solutions
1 The Dk-Lok swaging machine will not start Make sure to press the Start/Stop button
2 The machine is not receiving power.
Check the power cord connection. Check the power
switch and the power source.
3 When the swaging is not screwed into the
fixture smoothly.
It may occur because of the jig key Interfering with
the jig thread. You need to screw in the jig key so
that it dose not interfere.
4 When tubing is not well swaged.
You need to change the swaging pressure up and
down from The Values show in Table 1. In case
ferrules grip too strongly, you may set the pressure
down.
In case ferrule does not grip enough, you may
increase the pressure. If you still have the problems
unsolved, you may ask to authorized distributor or
Dk-Lok
head office in South Korea.