67 / 360
66
2015 Power Transmission Products
Banded
Available in a wide variety of sizes
Continental ContiTech Torque Team® Laminated V-belts are
available in the 5VL belt cross section and in most standard
lengths. The 5VL laminated V-belt is interchangeable with all
standard 5V and 5VX V-belts currently found on these drives.
They can also be cut to a variety of rib widths, depending on
your drive requirements. This ensures a perfectly-matched set
of V-belts that can further enhance drive performance.
5VL Cross Section View
Applications
Some of the most common drives recommended for
consideration include:
›
Debarkers
›
Gang saws
›
Chip-n-saws
›
Deck saws
›
Cut-off saws
›
Trimmers
›
Chippers
Key features & benefits
›
Narrow profile ribs provide savings through efficiency.
›
Joined construction for problem drives.
›
High horsepower capacity.
›
High-strength Vytacord® tensile members.
›
Laminated construction engineered to slip.
›
Tough fabric backing.
›
Oil, heat, ozone and abrasion resistant.
›
Static conductive.*
*Drive conditions and service variables in combination with time in
operation can result in a loss of static conductivity. It is recommended
that a conductivity check be added to drive preventive maintenance
programs where belt static conductivity is a requirement.
Reduce downtime and maintenance
Continental ContiTech Torque Team® Laminated V-belts can
withstand the punishment that results from jams in log and
lumber processing applications.
Standard V-belts resist slipping when a jam occurs, causing
excessive heat buildup that can lead to belt failure and costly
downtime. But that won’t happen with Torque Team®
Laminated V-belts on the job.
The special sidewall of Torque Team® Laminated V-belts acts
as a control switch, allowing the belts to slip as needed until the
obstruction is cleared. As a result, the superior wear-resistant
capabilities of Torque Team® Laminated V-belts are maintained,
increasing belt life up to four times longer than standard V-belts.
High strength for long life
Continental ContiTech Torque Team® Laminated V-belts feature
our powerful Vytacord® tensile members. Vytacord® provides
high strength and horsepower ratings, yet serves as a more
forgiving reinforcement that will give under excessive tension
instead of snapping. That means increased belt life.
Part Number: 3/5VL800
3/
3 rib joined construction
5V
0.62 in. top width – Narrow
profile rib
L
Laminated construction
800
80.0 in. nominal outside length
Torque Team
®
(Laminated) V-Belts
Solve the toughest sawmill
drive problems
Continental ContiTech Torque Team® Laminated V-belts are
particularly effective when installed on drives that experience
frequent slippage caused by logs and heavy lumber that jam
or impact the equipment.
Sizes
5VL800
5VL1000
5VL1250
5VL850
5VL1060
5VL1320
5VL900
5VL1120
5VL1700
5VL950
5VL1180
For longer 5V, as well as 3V and 8V laminated profiles not listed here, contact your
PTP Industrial Distributor.
Overview
Synchronous
Banded
V-Belt
Bushing Hardware
Specialty
Automotive & Truck
General Information