Goodyear Rubber Products
CALL
TOLL FREE
IN THE USA
1-866-711-4673
INTERNATIONAL SALES CALL
+1-727-342-5086
WE SHIP WORLDWIDE
International Sales Click Here
Get A
Quote
Now
Home
About Us
Product Brands
Catalogs
Contact Us
Locations
Corporate Headquarters,
Clearwater, Florida, (FL)
Parker Store, Bradenton, Florida, (FL)
Parker Store, St. Petersburg, (FL)
Parker Store, Ft. Myers, Florida, (FL)
Parker Store, Naples, Florida, (FL)
Parker Store, Tampa, Florida, (FL)
<< Previous Page
Click Here
to open this page in a new window.
Next Page >>
SHAFT MOUNTED ASSEMBLIES SHAFT MOUNTED ASSEMBLIES SLIP FIT � LIGHT/HEAVY DUTY PRESS FIT Bearing Bearing 660TM Quick Metal� or 680TM Shaft 609TM (641TM) ORIGINAL 1. Machine shaft to .002" radial slip fit with 50-80 rms finish (second cut). Shaft 2. Clean all parts with Loctite� ODC-Free Cleaner & Degreaser. 3. Spray all parts (I.D. and O.D.) with Loctite� 7649TM Primer NTM. Do NOT use primer for heavy duty applications. STANDARD 4. Apply a Loctite� 660TM Quick Metal� Retaining Compound coating around shaft and engagement area. 1. Clean shaft O.D. and component I.D. 5. Assemble parts with rotating motion. 2. Apply a bead of Loctite� 609TM (641TM) Retaining Compound to circumference of shaft at leading edge of insertion or leading area of engagement. 6. Wipe off excess. Note: � Retaining compound will always be squeezed to the outside 7. Allow 2 hours prior to service. when applied to shaft. WORN SHAFT � Do NOT use with Loctite� Anti-Seizes or similar product. Follow directions above except: 3. Press as usual. Wipe off excess. 1. Determine radial gap. 4. No cure time required. 2. If radial gap exceeds .005", Loctite� 7649TM Primer NTM must be used. Note: Loctite� 609TM (641TM) Retaining Compound is used due to low 3. Take steps to maintain concentricity with large gaps. viscosity and wetting properties. 4. Larger gaps require longer cure times (30-60 minutes). 5. Loctite� 660TM Quick Metal� Retaining Compound is NOT recommended TANDEM MOUNT for radial gaps exceeding .010". 1. Apply retaining compound to bore of inside component. 6. See procedure for BADLY WORN SHAFT page 19. 2. Continue assembly as above. Note: Loctite� 660TM Quick Metal� Retaining Compound is very fast fixturing (30 seconds or less) with Loctite� 7649TM Primer NTM. MAXIMUM STRENGTH 1. Same as above, except use Loctite� 680TM Retaining Compound with Loctite� 7471TM Primer NTM or no primer. 2. Allow 4-24 hours to cure. MAXIMUM TEMPERATURE (400�F continuous) 1. Same as above, except use Loctite� 620TM Retaining Compound with Loctite� 7471TM Primer NTM. 20 21
Goodyear Rubber Products
