Goodyear Rubber Products
CALL
TOLL FREE
IN THE USA
1-866-711-4673
INTERNATIONAL SALES CALL
+1-727-342-5086
WE SHIP WORLDWIDE
International Sales Click Here
Get A
Quote
Now
Home
About Us
Product Brands
Catalogs
Contact Us
Locations
Corporate Headquarters,
Clearwater, Florida, (FL)
Parker Store, Bradenton, Florida, (FL)
Parker Store, St. Petersburg, (FL)
Parker Store, Ft. Myers, Florida, (FL)
Parker Store, Naples, Florida, (FL)
Parker Store, Tampa, Florida, (FL)
<< Previous Page
Click Here
to open this page in a new window.
Next Page >>
GASKET DRESSING FORM-IN-PLACE SILICONES SEALED FLANGES STAMPED OR SHEET METAL FLANGES Primer NTM and 518TMGasket Eliminator� 2440TM (QuickStixTM 534TM) 2440TM 1. Remove old gasketing material and other heavy contaminants with Loctite� Chisel� Gasket Remover. 2. Clean both flanges with Loctite� ODC-Free Cleaner & Degreaser. 3. Apply a continuous bead of Loctite� Instant Gasket or Loctite� high performance silicones to sealing surface. Circle all bolt holes. Note: � Use proper bead diameter to seal flange width and depth. 2440TM TM � Minimize excessive material "squeeze in". Primer N Only 4. Assemble within 10 minutes by pressing together. Tighten as required. 1. Remove old gasketing material and other heavy contaminants with 5. Clean up any excess or squeeze out. Loctite� Chisel� Gasket Remover. Use mechanical removal technique 6. Cure times will vary with temperature, humidity, and gap. Typical full if required. cure time is 24 hours. Note: Avoid grinding. 2. Clean both flanges with Loctite� ODC-Free Cleaner & Degreaser. Loctite� Instant Gasket* Loctite� 587TM Blue 3. Spray Loctite� 7649TM Primer NTM on both flange faces and both sides of COLOR Black Blue the precut gasket. Allow 1-2 minutes to dry. VISCOSITY, cP Paste Paste 4. Smear Loctite� Gasket Eliminator� Flange Sealant to both sides of 1 1 GAP FILL /4" /4" precut gasket with a clean applicator. CURE METHOD Moisture/Oxime Moisture/Oxime 5. Place coated gasket on flange surface and assemble parts immediately. CURE SPEED Note: � If cover bolts into blind holes (as above), apply Loctite� Tack-Free 30 minutes 30 minutes 2440TM Threadlocker into hole and on threads. Full Cure 24 hours 24 hours Tighten normally. SERVICE TEMP. RANGE � If it is a through bolt assembly, apply Loctite� 2440TM Intermittent -75�F to 500�F -75�F to 500�F Threadlocker or Loctite� QuickStixTM 248TM Threadlocker to -59�F to 260�C -59�F to 260�C bolt threads. 6. Tighten normally. *Loctite� Instant Gasket provides a low pressure instant seal (100 psi at zero gap). 14 15
Goodyear Rubber Products
