Goodyear Rubber Products
CALL
TOLL FREE
IN THE USA
1-866-711-4673
INTERNATIONAL SALES CALL
+1-727-342-5086
WE SHIP WORLDWIDE
International Sales Click Here
Get A
Quote
Now
Home
About Us
Product Brands
Catalogs
Contact Us
Locations
Corporate Headquarters,
Clearwater, Florida, (FL)
Parker Store, Bradenton, Florida, (FL)
Parker Store, St. Petersburg, (FL)
Parker Store, Ft. Myers, Florida, (FL)
Parker Store, Naples, Florida, (FL)
Parker Store, Tampa, Florida, (FL)
<< Previous Page
Click Here
to open this page in a new window.
Next Page >>
BeBe SafeSafe WhenWhen UsingUsing QuickQuick Couplings!Couplings! Quick disconnect couplings can fail without warning! Prior to the operation of quick coupling products, be sure to inspect and replace worn out fittings and safety devices. If a leak is detected during operation, release the pressure from the circuit before investigating the cause of the fluid leak. Do not use your fingers or skin to check for leaks, high pressure leaks Warning! of fluids can easily penetrate the skin and can cause serious injury or death. Safe Quick Coupling Practices 1. Always wipe the coupling cavities and faces clean before connecting a coupling. 2. Connect coupling before installation to ensure that it works properly. 3. Always check the body seals before connecting a coupling. 4. Shut-off power source before connecting a coupling. 5. Always install a Safety-Check valve on a pneumatic line and/or compressor. 6. Always use a Safety-Cable on large air lines (�" lines and larger). 7. Always use a Whip Hose on hydraulic or air tools. 8. Use dust caps or plugs when couplings are not in use. 9. If the locking sleeve is inoperable, check the safety lock. Smart! 10.Wear eye protection while connecting or disconnecting a coupling. Unsafe Quick Coupling Practices 1. Never hit coupling valves to release trapped pressure. 2. Never leave couplings in the path of moving equipment. 3. Never use couplings near a welder, flash heat, or fire / flame sources. 4. Never use API modified sealants or over apply PTFE tape. 5. Use care if you must install quick couplings onto black iron pipe. 6. Never hit a coupling sleeve with a hammer or blunt object. 7. Never overtighten a coupling connection. 8. Never rotate a quick disconnect coupling under pressure. 9. Do not overpressurize quick disconnect couplings. Not Smart! 10.Never use a hose with a quick disconnect coupling to lift a tool. OSHA Regulations Ensure Operator Safety Standard - 29 CFR, 1926.302 (partial): (b)(1) Pneumatic power tools shall be secured to the hose or whip by some positive means to prevent the tool from becoming accidentally disconnected. (b)(2) Safety Clips or retainers shall be securely installed and maintained on pneumatic impact (percussion) tools to prevent attachments from being accidentally expelled. Safety Cables (Page 39) (b)(4) Compressed air shall not be used for cleaning purposes except where reduced to 30 PSI and then only with effective chip guarding and personal protective equipment which meets the requirements of Subpart E of this part. The 30 PSI requirement does not apply for concrete form, mill scale and similar cleaning purposes. (b)(5) The manufacturer's safe operating pressure for hoses, pipes, valves, filters and other fittings shall not be exceeded. BeSafe!! (b)(6) The use of hoses for hoisting or lowering tools shall not be permitted. (b)(7) All hoses exceeding �" inside diameter shall have a safety device at the source of supply or branch line to reduce pressure in case of hose failure. Safety Check Valves (Page 46) Standard - 29 CFR, 1926.603 (partial): (a)(9) Steam hose leading to a steam hammer or jet pipe shall be securely attached to the hammer with an adequate length of at least �" diameter chain or cable to prevent whipping in the event the joint at the hammer is broken. Air hammer hoses shall be provided with the same protection as required for steam lines. (a)(10) Safety chains, or equivalent means, shall be provided for each hose USC-Series Safety Coupler (Page 16) connection to prevent the line from thrashing around in case the coupling becomes disconnected. Dixon Quick Coupling 3 pages 001 - 013.pmd 3 8/24/2007, 10:16 AM
Goodyear Rubber Products
