71 / 103
71
Tel: +1.314.739.9191 • +1.800.288.2726 • Fax: +1.314.739.5880 •
www.tapcoinc.comBELT CLAMP FASTENER
FOR ELEVATOR BELTS
•
One size fits all pulley diameters.
•
Recommended for belts rated up
to 800 PIW, and up to 1/2” overall
thickness.
•
Holds belts in a vice-like grip
between three heavy duty grooved
plates, designed to remain secure.
•
The joint never touches the
pulleys. There’s no problem of
metal to metal contact.
•
Offers extra safety and
increased load capacity
because belt is not weakened
with excess bolt holes.
•
Each splice set joins a 2”
wide belt area.
•
Puts an end to the double
belt thickness common to other
systems. Stops the costly waste
of extra belting necessary in lap
and butt rider splices .
•
Can be used over and over
again for years of dependable
service.
Strong!
Safe!
Dura-Splice
™
Standard
Cast Ductile Iron (Zinc Plated)
Tapco-Splice NS
Non-Sparking
Cast Bronze
Dura-Splice Weight 3.0 lbs
Tapco-Splice Weight 3.5 lbs
Dura-Splice Supplied with 4” Grade 5 bolt and compression lock nut *
Tapco-Splice Supplied with 4-1/2” Grade 5 bolt and compression lock nut *
* do not reuse
Reliable!
Proven!
Template tape available at no charge. Just peel and stick.
When reinstalling the Tapco-Splice, always use a new bolt and nut assembly.
Contact Tapco for replacement parts.
Not recommended for “wing” type pulleys.
Do not mix parts from different types of splices.
For creating holes in belting, use either a 1/2” diameter drill bit
or the 1/2” diameter Tapco-Punch.
Punch sold separately