Conveyor Belt Group
ContiTech Transportbandsysteme GmbH
D-37154 Northeim
Tel. +49 5551 702-1643
transportbandsysteme@cbg.contitech.deInstructions for Use
one
step – one solution
Conti Secur
®
PREMIUM
WT 7984 E 10.12
The content of this publication is not legally binding and is provided as information only. The trademarks
displayed in this publication are the property of Continental AG and/or its affiliates. Copyright © 2012 ContiTech AG.
All rights reserved. For complete information go to:
www.contitech.de/discl_en www.contitech.de/cbg-csp-eConti Secur
®
PREMIUM
The one-component adhesive based on polychloroprene.
Rubber-to-rubber adhesion
1. Preparation of the cold bonding
1.1 Clean the surface of the rubber using cleansing agent (CCS).
Allow the cleaning agent to evaporate off for at least 10 minutes
at room temperature.
1.2 Roughen the surface of the rubber using a grinder.
Caution:
Minimum speed: 800 U/Min.
Maximum speed: 2000 U/Min.
Remove the grinding dust dry.
2. Bonding
2.1 The surfaces or materials that are to be glued should preferably be at room temperature.
If the temperature is too low, we recommend warming up the surfaces/materials.
2.2 First application of Conti Secur
®
PREMIUM onto the gluing surfaces
Using a brush with short bristles, apply one thin coat of Conti Secur
®
PREMIUM
to the prepared rubber surfaces.
Drying time:
At least 30 minutes at room temperature
Caution:
At room temperature the maximum drying time
should not exceed 12 hours.
2.3 Second application of Conti Secur
®
PREMIUM to the gluing surfaces
Drying time:
Maximum of 10 minutes at room temperature (test with back of hand).
Note:
A third application of adhesive may be required if the surface is particularly rough.
The drying time for the second application is then also at least 30 minutes.
2.4 Put the surfaces to be glued together. Press on the surfaces from the inside outwards,
e.g. using a hand-held roller. The required contact pressure depends on the properties
of the surfaces.
Caution:
Brief contact pressure is sufficient. Optimum adhesion strength
is attained after approx. 24 hours.