866-711-4673 Goodyear Rubber Dixon

Safety &

Technical

939

DPL418

877.963.4966 •

Identifying Threads

It is important to identify the threads required before ordering couplings.

Identifying threads can sometimes be the most difficult and frustrating part of coupling selection. However, without the right

combination of threads, you may not provide a functional or safe connection.

The diameters, threads per inch (TPI) and thread pitch, etc. are necessary to completely identify a thread. Ring, plug and

GO/NOGO gauges are required to accurately gauge or identify threads. In the field, in the absence of these gauges, thread

leaf gauges can be used to identify the Threads Per Inch (TPI) and the thread pitch. On threads you have determined to be

straight threads, a caliper can be used to measure the Outside Diameter of the male (ODM) or the Inside Diameter of the female

(IDF). A caliper can also be used to take measurements of tapered thread diameters. However, these are more difficult to

define because of the taper. Fortunately, there are few tapered threads to deal with and these can usually be identified from the

nominal ODM and the TPI.

However, identifying the thread may not fully identify what is needed in a mating fitting. The application is the primary

limiting

factor on the thread type used.

Dixon

offers products with a wide variety of threads used with hose, pipe and hydraulics.

When attempting to choose a fitting, it is always advisable to first identify the thread to which it must connect. This may entail

checking with a fitting or equipment manufacturer.

The fire hose thread specifications for some local municipal fire equipment and hydrants may vary according to local

specifications. These can generally be most easily identified by contacting the local fire department responsible for the hydrant.

The most common thread used on fire equipment is National Standard Thread (NST), also known as National Hose thread

(NH).

When it is not possible to identify the thread:

1. Determine the number of threads per inch by measuring the distance from peak of thread to peak of thread across the largest

number of whole threads. Then divide the number of threads by the measurement (this will provide the TPI).

2. Check to see if the thread is straight or tapered.

a)Straight Threads

Measure the Outside Diameter of the Male (ODM) or the Inside Diameter of the Female (IDF), from peak of thread to peak

of thread.

b)Tapered Threads

Measure the Outside Diameter of the Male (ODM) at the large end and the small end, or the Inside Diameter of the Female

(IDF) at the large end and the small end, from peak of thread to peak of thread. Then measure the Outside Diameter (OD)

of the unthreaded pipe.

Once the application and these two pieces of information have been determined, the thread can generally be determined. When

in doubt, call Dixon

at 800.355.1991.

Straight Thread

Tapered Thread

Thread Information