Page 246 - untitled

Parker Hannifin Corporation
Parflex Division
Ravenna, Ohio
240
Hydraulic &PneumaticHose & Fit.
PTFEHose &Fittings
Thermoplastic
Tubing
Coiled Air Hose,
Fittings
& Accessories
Truck (Fleet)
Products
Tooling &Equipment
Hose
Accessories
Technical &
Design
Information
Approvals &
Guides
Alphanumeric
Index
Hose Assembly & Crimping
ASSEMBLE
HOSE 7 ASSEMBLE
HOSE 8
PTFE HOSES
GPH HOSES
HYBRID & THERMOPLASTIC
Push fitting onto hose slightly
and then remove tape. Continue
pushing fitting onto hose until
fitting reaches depth insertion
mark. (If fitting does not read-
ily slide onto hose, perform the
next step.)
Using a SAE 20 lubricating oil,
lightly lubricate inside of hose
end. (Use soap solution for oxy-
gen service. This practice should
only be done if necessary.)
Push hose into fitting all the
way to depth insertion mark.
(If fitting does not readily slide
onto hose, perform the next
step.)
Insert hose into ferrule until
hose bottoms out against lip of
ferrule.
Insertbarbedendoffittingthrough
ferrule and into hose I.D.
NOTE: If HBL fitting is difficult to
install,waterorsoapsolutionmay
be used as a lubricant.
Push fitting inward completely
until hex of fitting is flush with
end of ferrule.
Tap fitting onto hose as follows:
Using Parker VBS or VBL vise
blocks, place hose with fitting
into proper hole of vise block and
place in bench vise.
ASSEMBLE
HOSE 9
CAUTION:
Ensure hose extends from vise
blocksonlyenoughtocleardepth
insertionmark. Failure to do this
may result in harmful kinking
of hose.
PTFE: For further instruction
on PTFE assembly, please proceed
to step 11.
GPH: For further instruction on
GPH assembly, please proceed
to step 11.