Goodyear Rubber Products
CALL
TOLL FREE
IN THE USA
1-866-711-4673
INTERNATIONAL SALES CALL
+1-727-342-5086
WE SHIP WORLDWIDE
International Sales Click Here
Get A
Quote
Now
Home
About Us
Product Brands
Catalogs
Contact Us
Locations
Corporate Headquarters,
Clearwater, Florida, (FL)
Parker Store, Bradenton, Florida, (FL)
Parker Store, St. Petersburg, (FL)
Parker Store, Ft. Myers, Florida, (FL)
Parker Store, Naples, Florida, (FL)
Parker Store, Tampa, Florida, (FL)
<< Previous Page
Click Here
to open this page in a new window.
Next Page >>
TechnicalAccessoriesEquipmentFittingsHose 88Series Catalog 4400 US 88 Series Fittings 88 Series Assembly Instructions Use with 811, 811HT, 881 hoses. 88 Series Hose Assembly Instructions 1. Identify Over All Length (OAL) of hose assembly and the Cut Off Allowance (COA) length of fitting(s) by use of the fitting A data table. Properly measure and mark hose. Cut hose cleanly and squarely to length. Trim any exposed wire rein- forcement to prevent injury in service. 1 2. Slide clamp(s) onto hose and lubricate hose. Push hose onto fitting until hose bottoms against stop ring or hex. 3. Position hose clamp(s) as shown and secure with a screw- driver or wrench. Maintain "A" dimensions as shown below B for proper clamp positioning of both HC clamps and HC-H clamps. 3A. Evenly attach double bolt clamps for maximum grip. 2 A Hose I.D. inch inch mm -12 1/4 6.35 -16 3/8 9.53 -20 3/8 9.53 -24 1/2 12.70 C -32 1/2 12.70 Note: For permanent installation of 88 Series Fittings, an 81 Series Crimp Shell must be added. See Equipment 3 Section for assembly and crimping instructions. I A D 3A E B-186 Hose Products Division Parker Hannifin Corporation Wickliffe, Ohio
Goodyear Rubber Products
