Goodyear Rubber Products
CALL
TOLL FREE
IN THE USA
1-866-711-4673
INTERNATIONAL SALES CALL
+1-727-342-5086
WE SHIP WORLDWIDE
International Sales Click Here
Get A
Quote
Now
Home
About Us
Product Brands
Catalogs
Contact Us
Locations
Corporate Headquarters,
Clearwater, Florida, (FL)
Parker Store, Bradenton, Florida, (FL)
Parker Store, St. Petersburg, (FL)
Parker Store, Ft. Myers, Florida, (FL)
Parker Store, Naples, Florida, (FL)
Parker Store, Tampa, Florida, (FL)
<< Previous Page
Click Here
to open this page in a new window.
Next Page >>
BRASS INVERTED FLARE BRASS FITTINGS Inverted Flare A Thread Size - B Tube 1/8 3/16 1/4 5/16 3/8 7/16 1/2 5/8 3/4 7/8 1 O.D. Thread 5/16-28 3/8-24 7/16-24 1/2-20 5/8-18 11/16-18 3/4-18 7/8-18 1-1/16-16 1-3/16-16 1-5/16-16 Size-B �Typical Application �Advantages Hydraulic brake, power steering, fuel lines and trans- Very low cost and reusable. Seats and threads are in- mission cooler lines, LP and natural gas. ternal and protected. Compact, excellent vibration life. Short nut affords very close tube bends. Steel or brass �Working Pressure Ranges tube nut. Temperature and type of tubing used are important factors. However, the following table is a good guide � Tolerance for proper selection. Temperature 730F with copper +/- .03 on all dimensions. Dimension data can change tubing: without notice. Please call us when dimensions are PSI Tube O.D. (in.) Tube Wall (in.) critical 2800 1/8 .030 �Conformance 1900 3/16 .030 Meets specifications and standards of ASA, ASME, 1400 1/4 .030 SAE and MS (Military Standards). 1200 5/16 .032 1000 3/8 .032 �Assembly Instructions 750 1/2 .032 1-Cut tubing to desired length. Make sure all burrs are removed and the ends are cut square. 650 5/8 .035 2- Slide nut on tube. Threaded end "A" of nut must 550 3/4 .035 face out. �Vibration 3- Flare end of tube with a 450 flaring tool. Excellent resistance. a- Measure flare diameter. b- Examine flare for excessive thin out. �Temperature Range -650F to +2500F (-530C to +1210C) range at c- On thin wall, welded or brazed tubing, use double flare to prevent pinch-off and cracked flares. maximum operating pressures. 4- Lubricate threads and assemble to fitting body. Nut should be turned hand tight. �Material 5- Tighten assembly with wrench until a solid feeling CA360 Brass. is encountered. From that point, apply a one-sixth turn. �Used With Copper, brass, aluminum and steel hydraulic Note: Do not over-torque as it may damage the fitting tubing that can be flared. or split the tubing at the flare. Actual O.D. of male inverted flare threads IDLAND ETAL FG. CO. 16
Goodyear Rubber Products
