Goodyear Rubber Products
CALL
TOLL FREE
IN THE USA
1-866-711-4673
INTERNATIONAL SALES CALL
+1-727-342-5086
WE SHIP WORLDWIDE
International Sales Click Here
Get A
Quote
Now
Home
About Us
Product Brands
Catalogs
Contact Us
Locations
Corporate Headquarters,
Clearwater, Florida, (FL)
Parker Store, Bradenton, Florida, (FL)
Parker Store, St. Petersburg, (FL)
Parker Store, Ft. Myers, Florida, (FL)
Parker Store, Naples, Florida, (FL)
Parker Store, Tampa, Florida, (FL)
<< Previous Page
Click Here
to open this page in a new window.
Next Page >>
BRASS FITTINGS 45� FLARE 0 45 Flare AA ThreadThread SizeSize- B - B Tube 1/8 3/16 1/4 5/16 3/8 7/16 1/2 5/8 3/4 O.D. Thread 5/16-24 3/8-24 7/16-20 1/2-20 5/8-18 11/16-16 3/4-16 7/8-14 1-1/16-14 Size-B �Typical Application CA377 Brass for forged fittings. LP and natural gas, flammable liquids, instrumentation, refrigeration, power �Used With steering, hydraulic and pneumatic systems. Copper, brass, aluminum and steel hydraulic tubing that can be flared �Working Pressure Ranges Temperature and type of tubing used are important � Tolerance factors. However, the following table is a good +/- .03 on all dimensions. Dimension data can change guide for proper selection. Temperature 730F with without notice. Please call us when dimensions are copper tubing: critical �Conformance PPPSSSIII TTTuuubbbeee OOOO...DDD.. ((iiinn...)))TTTTuuubbbeee WWWaaaallllll (((iiinnn...))))Meets specifications and standards of ASA, ASME, 2800 1/8 .030 SAE and MS (Military standards). 1900 3/16 .030 1400 1/4 .030 1200 5/16 .032 Assembly Instructions 1000 3/8 .032 1- Cut tubing to desired length. Make sure all burrs 750 1/2 .032 are removed and ends are cut square. 650 5/8 .035 2- Slide nut on tube. Threaded end "A" of nut must 550 3/4 .035 450 7/8 .035 face out. 3- Flare end of tube with a 450 flaring tool. a-Measure flare diameter b- Examine flare for excessive thin out. �Vibration 4- Lubricate threads and assemble to fitting body. Nut Good resistance - use long nut when greater should be turned hand tight. vibration resistance is required. BRASS 5- Tighten assembly with wrench until a solid feeling is encountered. From that point, apply a one-sixth �Temperature Range -650F to +2500F (-530C to +1210C) range at maxi- turn. Note: Do not over-torque as it may damage the mum operating pressures. fitting or split the tubing at the flare. �Material CA360 Brass for Barstock fittings. Actual O.D. of Flare Fittings IDLAND ETAL FG. CO. 1
Goodyear Rubber Products
