Goodyear Rubber Products
CALL
TOLL FREE
IN THE USA
1-866-711-4673
INTERNATIONAL SALES CALL
+1-727-342-5086
WE SHIP WORLDWIDE
International Sales Click Here
Get A
Quote
Now
Home
About Us
Product Brands
Catalogs
Contact Us
Locations
Corporate Headquarters,
Clearwater, Florida, (FL)
Parker Store, Bradenton, Florida, (FL)
Parker Store, St. Petersburg, (FL)
Parker Store, Ft. Myers, Florida, (FL)
Parker Store, Naples, Florida, (FL)
Parker Store, Tampa, Florida, (FL)
<< Previous Page
Click Here
to open this page in a new window.
Next Page >>
Acceptance / Approval FDA INERTEX UHF Joint Sealant meets the FDA requirements, PTFE - FDA21 CFR177.1550 Adhesive - FDA21 CFR175.105 DVGW German Federation of Gas and Water Technology According to DVGW No. 11G/Dr. Dri-PG, INERTEX UHF Joint Sealant is suitable for the gas supply at internal pressure up to 232 psig (16 bar) in the temperature range from 14�F (-10�C) to 122�F (50�C). BAM German Institute for Material Research and Test According to BAM No. 13621/87 4-4625, there are no reflections against the usage of INERTEX UHF Joint Sealant for the oxygen supply, sealing the flanges made of copper, copper alloy or steel at internal pressure up to 580 psig (40 bar) in the temperature up to 140�(60�C). TUV Technical Supervisory Federation of Bavaria in Germany, Materials and Structural Engineering Division, quality monitoring According to TUV No. 191604, MP3/7381, the characters of the sealing values are as per Chart I & Chart II on page 6. Custom Orders Other than the oval shaped cross-section, INERTEX UHF Joint Sealant can be supplied in various cross sections such as V-shape, square, rectangular and round as shown below, to fit into all kinds of flanges or sealing surfaces which have particular slots, grooves or special requirements of the cross-sections for easy installation. V-type, as a general practice, is to be stuffed with other materials such as fiberglass for certain specific applications. Please consult us for these custom-made INERTEX UHF Joint Sealant. Rectangle Round V-Type Square Overlapping Methods at the End Other than the regular method by crossing the ends at a bolt hole, here as shown (top view) are some examples for the applications where the extra bulk at the crossover could cause troubles. The data listed here fall within the normal range of product properties but should not be used alone as the basis of design. INERTECH, Inc. assumes no obligation or liability for any advice furnished herein or for results obtained with respect to the product(s). Buyer assumes sole responsibility for the results. G:\DOCSINER\InertexFiles\ADVERTIZ\REDBOOK\JSTECHR4.DOC 4/26/02 5
Goodyear Rubber Products
