Goodyear Rubber Products
CALL
TOLL FREE
IN THE USA
1-866-711-4673
INTERNATIONAL SALES CALL
+1-727-342-5086
WE SHIP WORLDWIDE
International Sales Click Here
Get A
Quote
Now
Home
About Us
Product Brands
Catalogs
Contact Us
Locations
Corporate Headquarters,
Clearwater, Florida, (FL)
Parker Store, Bradenton, Florida, (FL)
Parker Store, St. Petersburg, (FL)
Parker Store, Ft. Myers, Florida, (FL)
Parker Store, Naples, Florida, (FL)
Parker Store, Tampa, Florida, (FL)
<< Previous Page
Click Here
to open this page in a new window.
Next Page >>
BANDED JOINED BELTS BANDED JOINED BELTS Because of their banded construction, these belts tend to are matched belt sets. They are available in the classical cross prevent rollover and reduce vibration tendencies. Banded sections (A, B, C, & D), narrow cross sections (3V, 5V, & belts are usually better suited to unusual drive situations than 8V), and Poly-V� cross sections (H, J, L, & M). CLASSICAL AND NARROW BANDED V-BELTS Typical applications for banded V-belts include vertical shaft other and turn over in the grooves or even jump out of the drives, clutching drives, and V-flat drives. (V-belt drives are grooves. Banded V-belts eliminate such problems. where the inside of the belt drives a flat pulley on the slower Another advantage of banded V-belts is the considerable speed shaft.) degree of design flexibility they can provide since they operate Banded V-belts are recommended for use where belt vibration just as effectively when they, in turn, are used as match sets. A or belt whip causes unsatisfactory results when conventional two-belt unit for example, has sufficient lateral rigidity so as multiple V-belts are used. Such situations are not uncommon to not interface with the units in adjacent grooves. on drives with a combination of long belt spans and/or pul- sating loads as created by an internal combustion engine or reciprocating pumps and compressors. In such cases, belt whip may become so severe that belts interface with each TORQUE TEAM PLUS� (FLEXTEN�-REINFORCED BANDED V-BELTS) These belts are available for low-speed, high-power applica- and 8V banded belts are ideally suited to handle many of the tions which were previously considered to be in the domain applications that have been reserved for chain or gears. of chain or gears. Flexten-reinforced Torque Team Plus 5V POLY-V� (V-RIBBED) Poly-V belts are flat belts with a series of longitudinal ribs on Three cross sections, designated J, L and M, handle the same the driving face that mate with grooves in the sheave rim. range of industrial applications as narrow or classical belts. A Relatively thin, with a well-supported tensile member, these smaller section, H, is used for small sheave and miniature belts perform better than V-belts on drives with small sheave, drives. BANDED high speeds, reverse bends, and high-speed ratios. Poly-V belts generally run smoother than V-belts and their low weight makes them suitable for high-speed drives. 37 BANDED JOINED BELTS
Goodyear Rubber Products
