Goodyear Rubber Products
CALL
TOLL FREE
IN THE USA
1-866-711-4673
INTERNATIONAL SALES CALL
+1-727-342-5086
WE SHIP WORLDWIDE
International Sales Click Here
Get A
Quote
Now
Home
About Us
Product Brands
Catalogs
Contact Us
Locations
Corporate Headquarters,
Clearwater, Florida, (FL)
Parker Store, Bradenton, Florida, (FL)
Parker Store, St. Petersburg, (FL)
Parker Store, Ft. Myers, Florida, (FL)
Parker Store, Naples, Florida, (FL)
Parker Store, Tampa, Florida, (FL)
<< Previous Page
Click Here
to open this page in a new window.
Next Page >>
Flareless Bite Type Fittings Assembly Instructions The assembly of Brennan Steel and Stainless Steel Bite-Type Fittings involves four steps: 1) cutting, deburring and cleaning; 2) pre- setting the ferrule to the tubing; 3) ferrule bite inspection; and 4) installation. Cutting, Deburring & Cleaning assembly of bite-type fittings is dependent upon the ferrule traveling a prescribed distance into 1. Square-cut the seamless or welded-and-drawn the fitting throat. This allows it to "bite" into the tubing using a hacksaw with a fine-tooth blade, tube, creating a strong grip and seal. or a circular-toothed cut-off saw. Use only 1tubing that is fully annealed for bending and 8. The use of a Ferulset tool is recommended for flaring. sizes -08 through -32". 2. Remove all burrs and sharp edges on the tube by lightly deburring the I.D. and O.D. Ferrule Bite Inspection Emery paper may be used to perform this task. The following inspection procedures must be 3. Wipe the tube end completely with a clean completed prior to final assembly. cloth. Be sure to remove all metal chips from the tube end. 31. Disassemble the fitting. 2. The tube surface must have a raised ridge of metal that is at least 50% of the thickness of Pre-Setting Ferrule to the Tubing the leading edge of the ferrule. This procedure must be followed to ensure the 3. There must be a slight bow to the pilot section proper location of the ferrule to the tubing. of the ferrule. 1. Lubricate the fitting body thread and the 2 4. The tail of the ferrule should be snug against thread of the nut. the tube. 2. Slip the nut and ferrule over the deburred end 5. A slight indentation around the deburred end of the tube. The long, straight end of the ferrule of the tube indicates that the tube was bottomed must point toward the deburred tube end. in the fitting. If this indentation is not visible, 3. Lubricate the ferrule. the ferrule may not be properly seated. 4. Position the deburred tube end squarely on 6. Do not rotate the ferrule. the shoulder of the fitting body. 5. Manually screw the nut onto the fitting body Installation until it is finger-tight. 1. Finger-tighten the nut. 6. Put a reference mark on the nut and the tube. 2. Wrench-tighten the nut another 1/ 1 3 to /2 turn. 7. Hold the tube firmly on the fitting body and tighten the nut an additional 13/ 4 turns. Proper 4 B R E N N A N I N D U S T R I E S Atlanta � Cleveland � Dallas � Los Angeles � Seattle
Goodyear Rubber Products
