Page 24 - 18640 GC04 Cat Rev

24

®

LIGHTWEIGHT SLAT

Occasionally the need arises for small diameter slat type

pulleys which are used in small unloading and loading

conveyors.VAN GORP has designed a light weight slat

pulley in 4" - 5

1

/

8

" - 6" diameters. Since the diameter is

so small, it is impossible to use gussets in this pulley,

but the individual slat wing principle is applied. If an

excessive amount of moist, sticky material such as clay

or bulk fertilizer falls on the pulley and belt, it is possible

to stop the conveyor and then clean the material out of

the wing openings. This pulley is offered with solid bore

hubs in the 4", 5 1/8" and 6" diameters and a XT15 hub

in the 6" diameter. Solid bores have one key-way and

two set screws in each hub.

RUGGED FOR LONG LIFE

— Built for the stress and

strain of big loads...or unusually long, large conveyor

systems. Designed after the SNAP-BACK

®

and TURN

CLEAN™ wing pulleys. All welded steel construction.

Outer bars have a long radius surface for maximum trac-

tion and minimum belt wear. All pulleys are jig welded,

and accurate concentricity is assured because the con-

tact bar is hydraulically pressed against the exterior wing

edge and then welded together. Individual gussets are

welded continuously to each wing and the hub forming

a strong double-cone design.

Available on XT

®

,

Tapered Bore or

Q-D

®

Hubs. See

Page 32 for

Bushing

Locations

Lightweight Slat and

Extra Heavy Duty Wing Pulleys