Page 355 - 4300 Catalog Cover.pdf

Parker Hannifin Corporation

Tube Fittings Division

Columbus, Ohio

http://www.parker.com/tfd

S5

4300 Catalog

Equipment

Dimensions and pressures for reference only, subject to change.

Fig. S4 — 1” Hand Tube Bender

able handle can be used for reduced hand interference that occurs at the end of the

bending operation.

*Refer to max. wall/min. wall recommendations specified for medium duty inch benders.

Recommended

Radius to Min. Wall

Max. Wall Thickness

Tube

Without

Copper,

Steel,

O.D.

Centerline

Flattening

Aluminum Stainless Steel

Size (in.)

(in.)

Part No.

4

1/4

9/16

0.028

Any

0.083 ........

4-2829AH

6

3/8

5/16

0.032

Any

0.083 ........

6-2829AH

8

1/2

1 1/2

0.042

Any

0.083 ........

8-2829AH

1” Hand Tube Bender

Part No. 16-2829

For 1” O.D. tube in soft copper and aluminummaterials.This bender can be used in hands,

but mounting in a bench vise is suggested, especially for heavier wall thickness tube.

HOWTO USE:

Align marks and bend the tube to the desired angle (up to 180°) by pulling

steadily on the operating handle.The handle may be re-positioned for maximum leverage.

Bend angles are indicated on the radius block. (Detailed instructions are included with

the bender.) See the table below for technical data and part numbers.

Recommended

Radius to Min. Wall

Max. Wall Thickness

Tube

Without

Copper,

Steel,

O.D.

Centerline

Flattening

Aluminum Stainless Steel

Size (in.)

(in.)

Part No.

16

1

3 1/2

0.065

Any

Not ............

16-2829

Recommended

Hand Tube Benders – Metric

These are sturdy, easy-to-use hand tools for fast and accurate bending without kinks or

visible flattening. Individual sizes in ten models from size 5mm to 25mm are available.

Medium Duty Metric Hand Tube Benders

Designed and built for fast, accurate bends and long service life.

These are individual benders for six metric tube sizes (5mm, 6mm, 8mm, 10mm, 12mm

and 14mm). All of these benders will bend copper, aluminum, annealed steel and stainless

steel. These can be used in hands or mounted in a bench vise.

HOWTO USE:

Simply align the marks on the slide block and radius block, then bend to the

desired angle (up to 180°) by pulling steadily on the slide block handle. Bend angles are

indicated on the radius block, both front and back. (Detailed instructions are included with

each bender.) See the table below for technical data and part numbers.

Recommended

Radius to

Min. Tube

Max. Wall Thickness

Tube

Wall

Copper,

Steel,

O.D.

Centerline

Thickness

Aluminum

Stainless Steel

(mm)

Part No.

5

14.3

0.5

Any

1.0..........

2829-5mm

6

14.3

1.0

Any

1.5..........

2829-6mm

8

23.8

1.0

Any

1.5..........

2829-8mm

10

23.8

1.0

Any

2.0..........

2829-10mm

12

38.1

1.0

Any

2.0..........

2829-12mm

14

38.1

1.0

Any

2.0..........

2829-14mm

Fig. S5 — Medium Duty Metric

Hand Tube Bender

Benders