Page 138 - untitled

Parker Hannifin Corporation
Parflex Division
Ravenna, Ohio
132
Hydraulic &PneumaticHose & Fit.
PTFEHose &Fittings
Thermoplastic
Tubing
Coiled Air Hose,
Fittings
& Accessories
Truck (Fleet)
Products
Tooling &Equipment
Hose
Accessories
Technical &
Design
Information
Approvals &
Guides
Alphanumeric
Index
P 919 06 39 08 08 08 C 30 N/A
Prefix
Hose
Type
Fitting 1st End
Configuration
Fitting 2nd End
Configuration
Size
1st
End
Size
2nd
End
Hose End
Dash Size
Fitting
Material Length
Displacement
Angle
R= Field Attachable
Fitting
P= Permanent
Crimp 91N & 93N
Series
F= 91 Series Crimp
Blank= Steel
C= Stainless
B= Brass
Overall
Length
always
expressed
in inches
If elbow
fittings are
used
overall
length is
measured
from the
centerline
of the seat
Specified only if two
elbow fittings are used.
Starting with either end
as the far end,
measure the angle
clockwise to describe
the displacement of the
near end.
This assembly example reflects a 13/32" (-8) ID 919
hose with an SAE 1/2" female JIC 37° straight fitting
on the first end and an SAE 1/2" 90° female JIC 37°
elbow fitting on the other. The fittings are crimped
(permanently attached) and stainless steel. The
overall length is 30".
The first fitting part number is 10691N-8-8
The second fitting part number is 13991N-8-8
Special Notes
Assemblies are to be measured extreme end to end.
Exceptions:
1. Face seal type fittings shall be measured from
sealing face.
2. Where elbow fittings are used, measurement
shall be to the centerline of the sealing surface of
the elbow end.
3. "A-LOK" and "CPI" fittings are measured from the
tube stops.
1 03 91N 8 6
Type
End
Configuration
Code Series of Fitting End Size Hose Size Material
1=Crimp
2=Field Attachable
Blank=Steel or Brass/
Steel
B=All Brass
C=Stainless Steel
S= All Carbon Steel
Hose Assembly Nomenclature
Hose Fittings Nomenclature
NEAR
END
FAR
END
270°
This example describes a permanent crimp 1/2" Male SAE JIC 37° hose end with a 5/16" hose end-this com-
monly referred to as a "jump size". This fitting is constructed from carbon steel since the designated material
is blank.
The callout is: 10391N-8-6
Other end configuration codes found on page 40.
PTFE Hose Assembly & Fittings Nomenclature