Page 99 - Catalog4400.pdf
SEO Version
Pipe / JIC
B-7
Hose Products Division
Parker Hannifn Corporation
Wickliffe, Ohio
25 Series Fittings
Catalog 4400 US
Ass mbly Instructions
Use with
1. On the 08 end confgurations only, the use of a mandrel is required. This mandrel is
designed to set the proper gap between the nut and the shell. To match the correct ftting
with the proper mandrel part number refer to the table below.
2. The assembly mandrels can be used with a common bench vise or on the TH2-7 push-on
stand. Refer to Bulletin 4480-T13-USA for push-on stand instructions.
3. When using a common bench vise, place the mandrel in the vise, put the ftting on the
mandrel (nut frst) then push on the hose until it bottoms. Visually check the sight hole
on the side of the shell to assure that the hose is fully inserted.
4. Remove mandrel from ftting and check for proper gap between nut and shell.
(See table below).
5. Now crimp the ftting onto the hose. Refer to CrimpSource for correct crimp dies
and crimping dimensions.
6. Check for proper gap between nut and shell after crimp. (See table below)
BEFORE CRIMP AFTER CRIMP
NOTE:B dimension is measured from the back of the fully-seated nut to the start of
the crimp length. The nut must be free to swivel after crimping of the shell.
7. For all other 25 series fttings, use of mandrel is not necessary. Push ftting onto hose until
it bottoms. Visually check sight hole on the side of the shell to assure that the hose is fully
inserted.
Assembly Instructions
Fitting Part
Number
A Length
B Length
Required
Assembly
Mandrel
mm
inch
mm
inch
10625-6-6B 3.80
0.150
8.00
0.315
TH2-7M25-6
10825-6-6B 5.80
0.230
11.80
0.465
10625-8-8B 3.80
0.150
8.00
0.315
TH2-7M25-8
10825-8-8B 5.80
0.230
11.80
0.465
NOTE: The “Required Assembly Tool” must be used to assemble all fttings listed above.
Powered by FlippingBook Publisher