Page 88 - 14407_APG_Text

84
www.callapg.com 713-675-5271 FAX 713-675-2730
1-800-888-5223 FAX 1-800-444-3252
Set of two brass picks with two working ends on each pick. Plastic storage pouch is included.
Used to extract o-rings that have been installed. Particularly useful when o-rings have been in
service or when close tolerances are involved.
Style ORP O-Ring Picks
Style ORL O-Ring Lubricant
Barium base petroleum grease formulated to facilitate installation and extend service life of synthetic rubber seals. A
film applied to the seal itself as well as surfaces over which the seal will travel is suggested for best results. Combines
excellent surface adherence characteristics and lubricity with inherent water resistance. It is especially
recommended for low pressure pneumatic systems as well as reciprocating and low speed oscillating or rotary
applications. Well suited for most sealing service within a -20° to +300°F temperature range. However, it is
not recommended for use in systems having micronic filters or in contact with seals unsuited for petroleum
oil service such as silicone, butyl, or ethylene propylene rubber. If the conditions exist, use of Style
ORLS (see below) should be considered. (4 ounce tube)
Style ORLS O-Ring Lubricant (Super)
Silicone lubricant intended to complement Style ORL (above) in that it can be used with virtually any rubber polymer. It
can also be used over a wider temperature range and in most cases will provide better environmental protection to
the elastomer. It is recommended that this lubricant be used sparingly as only a thin film is necessary for best
results. It is useful with a wide variety of fluid media since it is quite inert. High pressure systems as well as
vacuum uses are typical applications where this lubricant is beneficial. It is useful from -65° to +400°F. It is
non-toxic and non irritating under normal conditions. It will not clog 30 micron filters and is unusually
moisture resistant and adheres with unusual tenacity. (2 ounce tube)
NOTES:
Assembly lubricants should always be used sparingly during application. A light film is all that is required. This is doubly important in cases 1 and 2
below.
1. When a thin film of Style ORL is used for assembly purposes only, the assembly may be subjected to higher temperatures, with limits determined by
the fluid and elastomer being used.
2. Use only a thin film of Style ORLS on silicone rubber if the temperature will exceed 300°F.
Style ORL Style ORLS
Type Barium grease High viscosity silicone fluid
Temperature Range °F -20 to + 180 (1) -65 to +400(2)
°(C) (-29 to +82) (-54 to +204)
Seal Use Hydrocarbon fluids General purpose
Pneumatic systems High pressure pneumatic
under 200 psi
Suitable For Fluorocarbon Fluorocarbon
UseWith Rubber Fluorosilicone Fluorosilicone
Compounds: Neoprene Neoprene
Nitrile Nitrile
Polyphosphazine Polyphosphazine
Polyacrylate Polyacrylate
Polysulfide Polysulfide
Polyurethane Polyurethane
Butadiene
Butyl
Ethylene Propylene
Isoprene
SBR (GRS)
Silicone(2)
Will PassThrough No Yes
Micronic Filters?