Page 10 - NovaFlex_MarineBroch (Page 1)

Lawrence Marine • Novaflex Hose Inc
Tel:336-578-2161 Fax:336-578-5554
Toll Free: 800-334-4270
www.novaflex.com • email: sales@novaflex.com
LIMITED WARRANTY
WARRANTY- LAWRENCE MARINE warrants its marine products to be free from defects in material and workmanship under conditions of normal use and service when installed and used in its proper non-commercial marine application
in accordance with all applicable federal, state and local laws. This warranty shall be for the term of up to ten years from date of purchase according to our literature, on the date of purchase. This warranty does not apply to products
which have been damaged for any reason after leaving the control of LAWRENCE MARINE, including but not limited to damage caused by abuse, misuse, negligence, accident, modification, installation, alteration, repair, or excessive
temperature or pressure. During the warranty period, if a product is found to be defective in material or workmanship, it will be replaced or repaired without charge if returned, with prior approval, in accordance with LAWRENCE MARINE’S
return good policy. Damage to the product incurred during packing or return shipping of the product is not covered under this warranty. Proof of purchase must accompany the return. The forgoing obligations state LAWRENCE MARINE’S
entire and exclusive liability and the buyers exclusive remedy for any claim or damages in connection with the sale or furnishing of products or parts, their design, installation or operation. LAWRENCE MARINE IN NO EVENT WILL BE
LIABLE FOR ANY DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY WARRANTIES, EXPRESS OR IMPLIED IN FACT OR BY LAW WHATSOEVER, AND ITS LIABILITY UNDER NO
CIRCUMSTANCES WILL EXCEED THE PURCHASE PRICE FOR THE PRODUCT. LIABILITY OF LAWRENCE MARINE UNDER ANY WARRANTY WHICH MAY BE IMPLIED BY LAW, INCLUDING WARRANTIES OR MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE, IS LIMITED SOLELY TO THE PERIOD OF TIME SET FORTH IN THIS WARRANTY. This warranty is designed as a LIMITED WARRANTY under the provisions of applicable federal law.
Some states do not allow limitations on how long an implied warranty lasts or do not allow exclusion or limitation of incidental or consequential damages. So the above limitations and exclusions may not apply to you. This warranty gives you
specific legal rights, and you may also have other rights which vary from state to state.
Lawrence Marine Extender silicone products are for use as described. Products with textile reinforce can be used in wet exhaust systems and used
on engine coolant systems. It is incumbent on the user or installer to insure the product is used in applications that do not exceed the rated working
pressure or temperature of the product.
1. When installing the Extender Silicon unit in wet exhaust systems, place the unit downstream from the water injection point so that the maximum
continuous temperature at its location does not exceed the rating of the Expender unit.
2. Install the unit over rigid piping with enough over lap to use 2 marine grade stainless steel worm gear clamps (minimum 1/2” wide) for safety.
5/8” & 3/4” clamps are recommended.
3. Inspect hose products every 6 months for serviceability (see Lawrence Marine Care, Use and Maintenance Booklet (Form# 2003-2). In case of an
engine backfire, inspect the entire exhaust system for damage, leaks or separated connections.
Lawrence Marine part of “The NovaFlex Group” has been building marine hoses for more than 50 years. We now use this
manufacturing expertise to provide silicon products designed to meet the most rigorous requirements found in the Marine Industry. North
American made insures a consistency of product not found in imports. Extender silicon provides long lasting, high quality products, made
from ozone, heat and chemical resistant materials for added safety and economical performance!
Extender 350 90°
Elbow Connector
Extender 500 90°
Elbow Connector
(aramid fabric)
Part No. ID” OD” Leg
Length
Radius Wall
202V90-02000-00 2” 2.38” 6” 4” .18”
202V90-02500-00 2.5” 3.38” 6” 4” .18”
202V90-03000-00 3” 3.38 6’ 4’ .18”
202V90-03500-00 3.5” 3.88” 6” 4” .18”
202V90-04000-00 4” 4.38” 6” 4” .18”
202V90-04500-00 4.5” 4.88” 6” 4” .18”
202V90-06000-00 6” 6.38” 6” 4” .18”
Part No. ID/MM OD/MM Leg
Length
Radius Wall
202V45-02000-00 2”/50.80 2.38”/60.20 6” 4” .18”
202V45-03000-00 2.5”/63.50 76”/72.90 6” 4” .18”
202V45-04000-00 3”/76.20 3.36”/85.60 6” 4” .18”
202V45-04000-00 4”/101.60 4.38”/111.00 6” 4” .18”
202V45-06000-00 6”/152.40 6.38”/161.85 6” 4” .18”
Extender 350 45°
Elbow Connector
Extender 500 45°
Elbow Connector
(aramid fabric)
Extender 350 Silicon 45° connector is a softwall flexible
connector designed to provide maximum service life in pleasure
and commercial marine applications where vibration and minor
misalignment is an issue. Connector exceeds SAE J2006.
Cover: Metallic Blue
Construction: 4ply polyester construction to SAE J2006 standards
Temperature range: -65º to +350ºF (-54º to +177ºC)
Warranty: 10 years
Extender 350 Silicon 90° elbow connector is a softwall
flexible connector designed to provide maximum service
life in pleasure and commercial marine applications where
vibration and minor misalignment is an issue. Connector
exceeds SAE J2006.
Cover: Metallic Blue
Construction: 4ply polyester construction to SAE J2006 standards
Temperature range: -65º to +350ºF (-54º to +177ºC)
Warranty: 10 years
Extender 500 202X90 (500ºF) change V in part no. to X—all other
data is the same
Extender 500 202X45 (500ºF) change V in part no. to X—all
other data is the same