Assemblies
320
In order to make a quality assembly with GR14A hose,
the following instruction must be followed:
1.
Tape hose before cutting as shown.
This will prevent the wire from flaring once the cut is
made. If wire flare is allowed to occur, the ferrule will not
slide onto the hose.
2.
Slip ferrules on. Be sure they are in the correct direction
(
i.e. flange side aims to the outside of the hose.
3.
Push in on stem on each end.
4.
Remove the tape and slide the ferrule onto the stem.
Steps in GR14A Assembly
Appendix
Installation & Maintenance
Assemblies
Equipment & Accessories
Fittings
Hoses