Page 17 - 18640 GC04 Cat Rev

17
®
ROUGH TOP LAGGING
Rough Top Rubber Lagging is available in either
vulcanized or bolt on.
Vulcanized Rough Top is 60±5 durometer Shore A,
SBR Black Rubber. It is bonded directly to the pulley
rim in the vulcanizing process.
Bolt on Rough Top Lagging material is applied to the
pulley rim which is coated with a special bonding
adhesive and fastened to the pulley rim with strong self
tapping screws at the beginning and end of the lagging.
The top cover of both types of Rough top has thousand
of fingers that grip the belt. This irregular surface
increases the rubber’s tractive capacity and helps keep
the rubber clean.
SLIDE-LAG®
Quality rubber is bonded to special traction pads fitting the
pulley rim.The pads slide into retainers welded into the pulley
rim. New pads can easily be replaced without removing the
pulley from the conveyor.
Slide-Lag® is a registered trademark of Holz Rubber Co., Inc.
VULCANIZED RUBBER LAGGING
AND GROOVING
Vulcanized rubber lagging is 60±5 durometer Shore A,
S.B.R. black rubber without a cloth fabric. It is bonded
directly to the pulley rim in the vulcanizing process.The
finished rubber surface has a cloth impression. When
GROOVING is required, please specify whether
herringbone or another type of grooving is desired.
Normally, grooving should not be used in vulcanized
rubber less than 3/8" thick.
NOTE: Direction of grooving must be stated if we supply
the lagging and install a shaft. Normally
grooving should be run with the apex of the
pattern leading.
VULCANIZED LAGGING TOLERANCES
PLAIN WRAPPED CLOTH IMPRESSION LAGGING:
± 1 /8" on rubber thickness—no concentricity tolerance
guaranteed.
If you have an application for lagged pulleys that
demands exact concentricity, such as some elevator
pulleys, slide bed or reversing conveyor pulleys, then
we suggest that you order machined lagged pulleys.
True, this will cost more initially; however, in a tough
application, this cost would be offset quickly by additional
necessary labor when trying to train the belt.
Rubber Lagging
LAGGING TYPE
• VU-Vulcanized SBR 60 - 65 DUR
• VM-Vulcanized MSHA Neoprene
• VE-Vulcanized Static Cond.
Neoprene
THICKNESS
• 14 - 1/4 Inch
• 38 - 3/8 Inch
• 12 - 1/2 Inch
GROOVE TYPE
• R = None or Plain
• H = Herringbone
• C = Chevron
• D = Diamond
Pulley Diameter
Pulley Length
VU 12 R 04 06
Part Number Example