Page 226 - untitled

Parker Hannifin Corporation
Parflex Division
Ravenna, Ohio
220
Hydraulic &PneumaticHose & Fit.
PTFEHose &Fittings
Thermoplastic
Tubing
Coiled Air Hose,
Fittings
& Accessories
Truck (Fleet)
Products
Tooling &Equipment
Hose
Accessories
Technical &
Design
Information
Approvals &
Guides
Alphanumeric
Index
Part #: 015307,Upright Vise Mount
Machined and bent from ¼ inch thick 1018 steel. The mount connects to the
bottom of the MiniKrimp™ using four 3/8-16 bolts (bolts not included). Once
connected, the MiniKrimp™ can then be clamped into a vise for operation. Top
and side view shown.
Part #: 015306, Table Mount
Machined and bent from ¼ inch thick 1018 steel. The mount connects to
the bottom of the MiniKrimp™ using four 3/8-16 bolts (bolts not included).
The MiniKrimp™ can then be mounted to a table using the four 3/8 inch
clearance holes on the other side of the plate (bolts not included). Top and
side view shown.
Part #: 015309, High Pressure Hose Assembly
Parker 10,000 psi, ¼ inch ID hose with 3/8 inch female JIC connections on both ends. Hose is
6 feet long and is used when a flexible connection is required between the MiniKrimp and
a hydraulic pressure source.
Part #: 015308, Replacement Connector
Replacement stainless steel bent tube rigid connector for 94C-001-PFD (MiniKrimp Hand
Pump Model).
Part #: 025349, Replacement Connector
Replacement stainless steel bent tube rigid connector for 94C-002-PFD (MiniKrimp Air over
Hydraulic Model).
Part #: 045234, High Pressure Hose Assembly
Parker 10,000 psi ¼ inch ID hose with quick coupler. This hose i s designed to be
when mounting a hand pump to the 94C-MKS MiniKr imp™ stand’s base. See picture below.
for stand
used
MiniKrimp™
Crimping Machine
Note: The hydraulic connectors shown above are designed exclusively for use with the MiniKrimp. No other connectors are
approved for use with the MiniKrimp without expressed written consent from Parker Parflex Division's technical support. Any
worn connectors should be replaced immediately.