Page 263 - ParkerBrassCatalog2010

† U.S. Patent No. 5,683,120
I5 Parker Hannifn Corporation
Parker Brass Products Division
Otsego, Michigan
Catalog 3501E Prestomatic † Air Brake Push-In Fittings
I
Assembly Instructions
1. Cut tubing squarely–maximum of 15° angle allowable.
• Use of Parker tube cutter PTC-001 is recommended.
2.Check that port or mating part is clean and free of
debris.
3. Insert tubing into ftting until it bottoms.
• Push twice to verify that tubing is inserted past collet
and O-Ring.
4.Pull on tubing to verify it is fully inserted.
5.To disassemble, simply press release button, hold
against body, and pull tubing out of ftting.
Note: in order to pass hot pull requirements of
SAE FMVSS 571.106 and SAE J2494-3 a tube support
must be present in the end of the ftting before fnal ftting
assembly.
Insert tubing until it bottoms
Depress button to remove tubing
PTC-001