Page 126 - ayout 1

Instal lat ion
The PT line of quick disconnect couplings comes with a wide
range of fittings including threaded, hose connection, and
flanged end. These couplings have been engineered to meet
specific requirements with large safety margins.
It is the responsibility of the end user to communicate to the
distributor the application & operating conditions the coupling
will be subjected. It is up to the distributor to supply the right
coupling for the application. PT Coupling Co. is available to
help you with a proper coupling recommendation.
For the type of application required, care must be taken to
insure proper connection and a positive seal. Improperly fitted
or applied connections can result in serious accident and/or
downtime. Under no circumstances shall the pressure rating
of the couplings be exceeded.
Operat ion
PT couplings provide for quick and frequent connections by
means of the camming action on the groove surface of the male
adapter. The male adapter is simply inserted into the female
coupler until contact is made with the gasket. Both cam arms
on the coupler are then closed simultaneously to produce a
uniform gasket compression between the seal surfaces.
The compression on the gasket produces a seal when torque is
applied to the cam arms. A positive seal requires that the
surfaces on the gasket seat, the adapter face, and the gasket are
smooth and uncontaminated. Cam arms must be in the full
closed position for proper locking of coupling.
Gasket deterioration and excessive wear on cam, groove, and
seal surfaces can reduce the performance of the coupler.
Periodic inspection and servicing will ensure an efficient
and safe performance.
Maintenance
Couplings should be well maintained and inspected, particularly
when the conditions of service include high working pressure
and/or the transfer or storage of hazardous materials. Periodic
inspection and testing will detect signs indicating deterioration,
damage, or loss of performance before failure.
Gaskets: Use only gaskets approved by PT Coupling Company
The recommended seal material for a particular application has
its limitations. Initial installation of a seal material should be
followed by frequent inspections. This will help establish the
routine inspection and service cycle.
Replacement is required when gasket becomes hard, brittle, or
otherwise loses the characteristics required to perform in the
intended manner.
Couplers: Periodically check seal surfaces on both coupler and
adapter for signs of wear or corrosion. The adapter should be
checked for excessive wear on the groove surface where contact
is made with cam arms.
Cam arm and pin should also be periodically inspected for
excessive wear. Worn or otherwise damaged cam arms and pins
can prevent the coupler from operating in the intended manner.
To replace worn cam arm and pin, remove cam pin with hammer
and punch. Install properly selected new cam arm and pin
making sure the cam arm is positioned in the proper direction.
The cam arm handle should always be pointed away from the
female end of the cam and groove connection when the arm is
in the closed position. Safety goggles should be worn during this
procedure.
S a f e t y I n s t r u c t i o n s
PT Coupling Company • P.O. Box 3909 • Enid, OK 73702 • Tol l-Free: (800) 654-0320 • Tol l-Free Fax: (800) 828-2649 • Fax: (580) 237-3435 • info@ptcoupl ing.com • www.ptcoupl ing.com
130