Page 16 - NovaFlex_MarineBroch (Page 1)

Silicon Rubber & EPDM Molded or
reinforced connectors
Novaf lex Marine Extender silicone and EPDM rubber products are
for use as described. Products with textile reinforcement can be
used in wet exhaust systems and used on engine coolant systems.
It is incumbent on the user or installer to insure the product is used
in applications that do not exceed the rated working pressure or
temperature of the product.
1. When installing the Extender Silicon or EPDM units in wet
exhaust systems, place the unit downstream from the water
injection point so that the maximum continuous temperature at
its location does not exceed the rating of the Expender unit.
2. Install the unit over rigid piping with enough over lap to use 2
marine grade stainless steel worm gear clamps (minimum 1/2”
wide). For additional safety 5/8” & 3/4” clamps are
recommended.
3. Inspect all rubber & plastic products every 6 months for
serviceability. In case of an engine backfire, i nspect the entire
exhaust system for damage, leaks or separated connections. All
inspection information in this booklet can be applie d to
connectors.
Molded parts have no reinforcement. It is important to strap and
support all parts to prevent movement and possible disconnectio n
due to vibration. In addition it is important to insure that the weight o f
hoses and other equipment attached to connectors do not place
forces on the connectors that will promote disconnection at the
attachment point.
LIMITED WARRANTY
NOVAFLEX MARINE warrants its marine products to be free from defects in material and workmanship under conditions of
normal use and service when installed and used in its proper non-commercial marine application in accordance with all
applicable federal, state and local laws. This warranty shall be for the term of up to ten years from date of purchase according
to our literature, on the date of purchase. This warranty does not apply to products which have been damaged for any reason
after leaving the control of NOVAFLEX MARINE, including but not limited to damage caused by abuse, misuse, negligence,
accident, modification, installation, alteration, repair, or excessive temperature, ozone or pressure. During the warranty
period, if a product is found to be defective in material or workmanship, it will be replaced or repaired without charge if
returned, with prior approval, in accordance with NOVAFLEX MARINE’S return good policy. Damage to the product
incurred during packing or return shipping of the product is not covered under this warranty. Proof of purchase must
accompany the return. The forgoing obligations state NOVAFLEX MARINE’S entire and exclusive liability and the buyers
exclusive remedy for any claim or damages in connection with the sale or furnishing of products or parts, their design,
installation or operation. NOVAFLEX MARINE IN NO EVENT WILL BE LIABLE FOR ANY DIRECT, INDIRECT,
SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY WARRANTIES, EXPRESS OR
IMPLIED IN FACT OR BY LAW WHATSOEVER, AND ITS LIABILITY UNDER NO CIRCUMSTANCES WILL
EXCEED THE PURCHASE PRICE FOR THE PRODUCT. LIABILITY OF NOVAFLEX MARINE UNDER ANY
WARRANTY WHICH MAY BE IMPLIED BY LAW, INCLUDING WARRANTIES OR MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE, IS LIMITED SOLELY TO THE PERIOD OF TIME SET FORTH IN THIS
WARRANTY. This warranty is designed as a LIMITED WARRANTY under the provisions of applicable federal law.
Some states do not allow limitations on how long an implied warranty lasts or do not allow exclusion or limitation of
incidental or consequential damages. So the above limitations and exclusions may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
NovaFlex 16
449 Trollingwood Road, Haw R
tel: (800)334-4270 fax:
Email: sales@novaflex.com
Marine H
Proper hose
care and main
Duty to Wa
Effective: O