Page 118 - MidlandMetalsCatalog2010baNN

117
B
RASS
ebuT
D.O 4/1 8/3 2/1 8/5 4/3
daerhT
B-eziS 42-61/7 42-23/71 02-61/11 81-61/3181-1
•Typical Application
Air brake systems except where temperatures exceed
+2000F or where battery acid can drip on tubing.
•Pressure
Maximum operating pressure of 150 PSI.
•Vibration
Fair resistance.
•Temperature Range
-400F to +2000F (-400C to +930C).
•Material
CA360 Brass
•Used With
NT Nylon Tubing - SAE J844 Type A and B.
• Tolerance
+/- .02 on all dimensions. Dimension data can change
without notice. Please call us when dimensions are critical
•Advantages
Easy to assemble (no tube preparation or flaring required.)
Built in tube support. May be used with copper tubing by
replacing nut, sleeve and insert with long nut and spheri-
cal sleeve. Insert should be removed for copper tubing
use.
•Conformance
Meets specifications and standards of SAE and DOT
FMVSS 571,106.
•Assembly Instructions
1- Cut tubing to desired length.
2-Slide nut and then sleeve on tubing. Threaded end of
nut “A” must face toward fitting body.
3-Insert tubing into the preassembled fitting. Be sure
tubing is bottomed in fitting.
4- Tighten nut to required torque as
indicated on chart.
Disassembling: Remove nut and pull tubing out of fit-
ting body. Insert will remain in tubing.
Reassembly: Push tubing and insert into fitting body
until it bottoms. Thread nut onto fitting body and
torque as in step 4.
D.O.T. Air Brake - Nylon Tubing
A
"A" Dim. Thread Size
You don't get anything clean without getting
something else dirty.
- Cecil Baxter
D.O.T. AIR BRAKE - NYLON TUBING BRASS FITTINGS