Page 74-75 - LT_3722_v8_MRO.qxp

PRESS FIT
SHAFT MOUNTED ASSEMBLIES
21
STANDARD
1. Clean shaft O.D. and component I.D.
2. Apply a bead of Loctite® 609™ (641™) Retaining Compound to circumference
of shaft at leading edge of insertion or leading area of engagement.
Note: • Retaining compound will always be squeezed to the outside
when applied to shaft.
• Do NOT use with Loctite® Anti-Seizes or similar product.
3. Press as usual. Wipe off excess.
4. No cure time required.
Note: Loctite® 609™ (641™) Retaining Compound is used due to low
viscosity and wetting properties.
TANDEM MOUNT
1. Apply retaining compound to bore of inside component.
2. Continue assembly as above.
Bearing
Shaft
609™ (641™)