Page 227 - publication

Master format 3 part specification
Introduction
Couplings
Outlets
Fittings
Val
ves &
Accesso
ries
HighPressure
Advanced CopperMethod (IPS)
DI-LOK
®
Nipples
Plain-EndFittings
HDPECouplings
Sock-It
®
Fittings
StainlessSteel Method
Roll
Groovers
Installation& Assembly
SpecialCoatings
DesignServices
Technical
Data
Master Format3 Part Specs.
PictorialIndex
CTS Copper
System
www.anvilintl.com 227
SECTION 15500 (CONT.)
Piping Specialties
Part 3 EXECUTION
3.1 EXAMINATION
A. Do not begin installation until substrates have been properly prepared.
B. If substrate preparation is the responsibility of another installer, notify Architect of unsatisfactory preparation before proceeding.
3.2 PREPARATION
A. Clean surfaces thoroughly prior to installation.
B. Prepare surfaces using the methods recommended by the manufacturer for achieving the best result for the substrate under the project conditions.
C. Provide openings as necessary to permit installation of piping or any other part of work under this Section.
D. Provide sleeves for piping penetrating foor and masonry walls.
E. This Contractor shall be responsible for establishing sizes and locations of all openings and lintels in new work and to transmit this information
to the Contractor whose work is involved at such time as to avoid cutting and patching.
F. All patching shall match adjacent surfaces.
G. Contractor shall inspect and take note of existing conditions along with the Owner's Representative to avoid disputes regarding the condition
of existing surface before work began.
H. Openings through existing concrete shall be core-drilled or saw cut.
3.3 INSTALLATION
A. Install in accordance with manufacturer's instructions.
3.4 PROTECTION
A. Protect installed products until completion of project.
B. Touch-up, repair or replace damaged products before Substantial Completion.
END OF SECTION
SECTION 15600
Pipes, Valves and Fittings for HVAC Heating and Cooling Systems
Part 1 general
1.1 SECTION INCLUDES
A. HVAC requirements.
1.2 RELATED SECTIONS
A. Section 07840 - Firestopping.
B. Section 08310 - Access Doors and Panels.
C. Section 15050 - Basic Mechanical Methods and Materials.
D. Section 15060 - Hangers and Supports.
E. Section 15500 - Piping Specialties.
1.3 REFERENCES
A. Manufacturers Standardization Society of the Valve and Fittings Industry (MSS) SP-127 Bracing for Piping Systems Seismic-Wind-Dynamic
Design, Selection, Application.
1.4 SYSTEM DESCRIPTION
A. Grooved products for steel and copper heating and cooling systems shall be used. Refer to Section 15050 - Basic Materials and Methods and
Section 15500 - Piping Specialties for related materials.
1. Galvanized fttings shall be used with galvanized pipe.
GL-2.10