Page 46 - Goodyear2011PTCatalog

P O W E R T R A N S M I S S I O N P R O D U C T S S Y N C H R O N O U S
44
S Y N C H R O N O U S
O p e n - E n d B e lt C o n f i g u r at i o n
Eagle Pd Acculinear belts are manufactured in open-end rolls with
a standard roll length of 300 feet. The belt is manufactured with
the tension members lying parallel to the belt edge so that the
load is equally distributed across all tension members. A common
application of open-end belts is in linear motion drives. Clamping
plates are available for open-end Eagle Pd Acculinear belts to
mechanically join the belt’s ends.
S p l i c e d B e lt C o n f i g u r at i o n
Lengths of open-end Eagle Pd Acculinear can also be thermetically
spliced to obtain any continuous length of endless belting. These
spliced Eagle Pd Acculinear belts are primarily used in light
conveyor applications, where long endless belts are required.
S p r o c k e t s
Eagle Pd Acculinear Sprockets for the polyurethane belt line are
available for all eight belt widths in a wide range of ­diameters.
The Eagle Pd Acculinear product shares the same sprockets as the
rubber Eagle NRG™ product. The only exception is with the “M”
(25mm width) and the “L” (50mm width) sprockets. These two
widths are stocked in aluminum and are offered in a limited size
range. All other sprocket widths are stocked either in ductile or
cast iron. Refer to the “Eagle Pd Acculinear Sprocket” section for
more ­information.
Eagle Pd Acculinear is available in 8 standard widths
(in 8 and 14mm pitch configurations)
Sample Part Number
Y - 8 - Pu - 16 - Std
Belt Type: Open-End
Belt Length: 800mm
Y = Eagle Pd 16mm Wide Belt
8 = 8mm Pitch
PU = Polyurethane
16 = Belt Width, in mm
STD = Belt Construction (STD = Standard Construction)
1: Y - 8 - PU - 16
2: M - 8 - PU - 25
3: W - 8 - PU - 32
4: L - 8 - PU - 50
5: B - 14 - PU - 35
6: G - 14 - PU - 52.5
7: 0 - 14 - PU - 70
8: R - 14 - PU - 105
Alphabet Designation
(denotes belt width, e.g.:
Y = 16mm wide belt)
Belt Pitch
(8mm or 14mm)
PU for
Polyurethane
Belt Width
in mm
State Belt
Construction
State “Open-End”
or “Spliced”
State Belt
Pitch Length
S p e c i a l B e lt C o n s t r u c t i o n s
In addition to the standard belt construction (polyurethane
backing material), Eagle Pd Acculinear is available in a variety
of special constructions. Several materials can be applied to the
back of the belt to enhance its performance in specific drive envi­
ronments. These backing materials are typically used when special
characteristics are required on the back of the belt to transfer specific
materials in conveyor ­applications.
A number of special backings are available on request. Refer to
the appropriate engineering manual or to the Web site for more
information on these special backings.
E a g l e A c c u l i n e a r ® ®
Linear Conveyance Application
(SPLICED BELT)
Linear Motion Drive
(Open-End Belt)