Page 77 - banneredTapco Catalog

77 Tel: +1.314.739.9191 • +1.800.288.2726 • Fax: +1.314.739.5880 • www.tapcoinc.com
1-1/2
2
2-7/16
3
3-7/16
B-24
B-32
B-39
B-48
B-55
0.11
0.21
0.42
0.47
1.25
Shaft
Diameter
(Inches)
Part
Number
Weight
(Pounds)
NYLON HANGER BEARINGS
Nylatron ® GS Bearings have precise amounts of molybdenum disulfde, a solid lubricant, added to Type 6/6 nylon to produce a moly flled nylon
distinguished by its steel gray color and greatly improved bearing characteristics. Available in both Styles A & B. The FDA approved bearings are
molded from white 101 nylon for use in the food industry. Available in Style A only.
LET NYLATRON® GS SMOOTH OUT YOUR OPERATION
. . . AND AT A SAVINGS!
Normally, with a product or component which brings about an accelerated performance, longer life, or more trouble free operation, the cost is
usually justifably higher than conventional components. . . yet, in the case of Tapco nylon bearings, the initial cost is LESS, or at least comparable to
ordinary bearings.
Coupled with this initial economy, numerous other savings are realized through lower maintenance, less wear on coupling shafts and the
reduction of proft robbing down time.
Their longer life, corrosion and abrasion resistance, makes them cost effective. Most chemicals fail to impair their smooth operation. There is
less heat generated during use, hence, they maintain established fts and running clearances over a greater temperature range.
Lubrication is normally desirable since it will improve the PV (Pressure and Velocity) rating as much as fve times. However, the built in
lubricant (molybdenum disulfde) is adequate in the event of lubricant failures. Depending upon loads, speeds and materials conveyed, bearings can,
and have been, operated successfully with no lubrication.
While the use of Tapco nylon bearings is primarily intended for most conveyor hanger applications involving moderate loads and speeds in
temperature ranges of -40 °F-to + 250°F I -40°C to + 121°C the unexcelled properties of this material will suggest other applications to the user.
FDA approved white 101 nylon also available
in Style “A” only
Molded from Nylatron® GS
(Color Gray)
Tapco Style A for hanger frames 26B, 28B,
220, 226 and 228.
Tapco Style B for hanger frames 19B, 18B,
17B, 217, 218 and 219.
POLMER CORPORATION®
Molded from Nylatron® GS
(Color Gray)
STYLE A
BEARING
STYLE B
BEARING
REDUCED WEAR ON
COUPLING SHAFT
ECONOMY LUBRICITY
Low
friction
CHEMICAL
RESISTANT
ABRASION
RESISTANT
WILL NOT
CORRODE
Shaft
Diameter
(Inches)
Part
Number
Weight
(Pounds)
1-1/2
2
2-7/16
3
3-7/16
A-24
A-32
A-39
A-48
A-55
0.15
0.25
0.50
0.70
1.50