Page 46 - banneredTapco Catalog

46 Tel: +1.314.739.9191 • +1.800.288.2726 • Fax: +1.314.739.5880 • www.tapcoinc.com
STYLE: AA.
DESIGN: Centrifugal discharge.
MATERIAL: Thermoplastic urethane.
METHOD OF MANUFACTURE: Injection molded.
COLOR:Beige (Tan).
TEMPERATURE RANGE: -60°F to + 212°F/-51° C to + 100°C.
FLAMMABILITY: The urethane used in Tapco buckets, meets the criteria
of the Underwriters’ Laboratory Bulletin No. 94 HB. It has been tested
under ASTM Test No. D635 and has a burn rate of 0.76”/min. it also
meets approval under motor vehicle safety standard No. 302, with a
burn rate of 0.0”/min.
DRILLING: No charge for standard belt or chain drillings when order totals
50 or more pieces of the same size. Contact Tapco for quotation on
orders of less than 50 and/or special drill pattern requirements.
VENTING: Available on request. Contact Tapco for recommendations.
USABLE CAPACITY: Tapco recommends using 75% of gross,
(100%) capacity.
SPACING: A common spacing would be nominal projection plus 4",
however both closer and greater spacings may be used depending
upon the application.
INTERCHANGEABILITY: Can be intermixed with existing metallic or
nonmetallic buckets. Some care should be taken that the leg does
not become too far out of balance. Bucket projection varies by
manufacturer and material. Check elevator for proper clearances.
Contact Tapco for recommendations.
AA Elevator Bucket
12
SIZES
STYLE AA
prime virgin
THERMOPLASTIC
URETHANE
FEATURES:
EXTREME ABRASION RESISTANCE, TOUGH AND FLEXIBLE,
UNIFORM DISCHARGE, NONSPARKING, NONCORROSIVE
TECHNICAL INFORMATION:
INDUSTRIAL STYLE FOR HANDLING:
PELLETIZED OR EXTRUDED FEEDS, SOYBEANS, FERTILIZERS, OYSTER SHELLS,
SALT, SAND, CHEMICALS, and OTHER ABRASIVE PRODUCTS
INSTALLATION: Fanged elevator bolts and nylon insert lock nuts are
recommended for pulleys 6" in diameter and over. No. 3 Eclipse slotted
head elevator bolts are recommended for pulleys under 6" in diameter.
Large fat steel (fender) washers must be placed inside the bucket
under the nuts. Check elevator for proper clearances.
FDASTATUS: Our standard urethane does not meet the requirements for
FDA approval. FDA approved urethane is available, special order.
RECOMMENDATIONS: AA urethane buckets are ideal for use with
foundry sand, gravel, coal, fertilizer, clay salt, and many other industrial
materials. They are excellent for extremely high throughput elevators
LIMITATIONS: Urethane buckets should not be used on the following:
(1) Materials over 212°F/100°C. (2) Large dense materials such
as gravel and ores over 3/8" in diameter. (3) Some sharp sluggish
materials such as large glass cullet.
CAUTION: Welding and cutting on elevator legs without taking proper
precautions is extremely dangerous and can cause a violent explosion.
Urethane buckets can be ignited and will burn from improper welding
and cutting.
IMPORTANT: When elevating certain materials that harden or setup
with moisture, a Tapco metallic digger bucket should replace every
10th urethane bucket. In some instances ductile iron AA style buckets
(See page 43) will not have suffcient projection to protect the urethane
bucket. It will be necessary to use a pad or spacer behind the digger
bucket. Contact Tapco for recommendations.
IN STOCK FOR IMMEDIATE SHIPPING
AVAILABLE THROUGH INDUSTRIAL DISTRIBUTORS, CONTRACTORS, AND ORIGINAL EQUIPMENT MANUFACTURERS
SEVERE DUTY URETHANE